The XPD-924D 24 Shaker S24 is an automated DTF powder shaker and curing system built for professional direct to film production environments. It applies adhesive powder evenly and cures printed film with controlled heat, allowing operators to maintain consistent output.

In a DTF workflow, the shaker sits between printing and heat transfer. Because powder application directly affects adhesion, this system stabilizes coverage while removing excess material. As a result, transfers cure evenly and release cleanly during pressing.

Meanwhile, the integrated curing section activates adhesive powder at controlled temperatures. This process reduces inconsistencies caused by manual handling and helps operators maintain predictable results across daily production runs.

For this reason, the S24 integrates directly with 24 inch DTF printers such as the XPD-924D platform. It is intended for use with compatible DTF films, powders, and ink systems when operators follow recommended operating guidelines.

FEATURES

• Automated powder application for direct to film workflows
• Integrated curing chamber with controlled heat output
• Designed for 24 inch DTF film width
• Helps reduce powder waste and oversaturation
• Supports consistent adhesive coverage across prints
• Improves transfer quality and wash durability
• Reduces manual handling during production
• Built for continuous commercial operation

WHY IT IS RECOMMENDED

DTF production demands control at every stage. The XPD-924D 24 Shaker S24 is recommended because it standardizes powder application and curing, two steps that commonly cause transfer failures when handled manually.

Additionally, automated shaking reduces powder waste while improving edge clarity. Operators spend less time correcting mistakes, and therefore maintain higher throughput with fewer rejected prints.

Finally, the S24 supports production growth. Shops running repeat jobs benefit from consistent results across films and powders, which helps protect garment quality and long term wash durability.

FAQ

What does the XPD-924D 24 Shaker S24 do in a DTF workflow?
It applies adhesive powder evenly and cures printed DTF film before heat pressing.

Is this shaker compatible with the XPD-924D printer?
Yes. It is designed to pair with 24 inch DTF printers, including the XPD-924D.

Does this unit cure the adhesive powder?
Yes. It includes an integrated curing section for proper adhesive activation.

Can this reduce powder waste?
Yes. Controlled shaking helps remove excess powder and improve efficiency.

Is this suitable for daily production use?
Yes. It is built for commercial DTF environments and consistent operation.

For best results, pair the XPD-924D 24 Shaker S24 with STS DTF film, approved TPU powder, and STS DTF ink systems to maintain consistent transfer quality across production runs.